The legendary sound of the stereo bus compressor has been used on countless recordings for over 40 years. Nicknamed "mixbus glue," this compression sound has become the industry standard. WesAudio has improved this design, creating a whole new level of versatility with incredible, modern DAW integration. ngBusComp is a "fully analog" compressor with digital recall and plug-in control of all parameters. It can be used in three modes: dual mono, stereo, and mid-single. A next-generation stereo bus compressor with digital recall. Listen to this page (external site). Features: The legendary sound of the stereo bus compressor has been used on countless recordings for over 40 years. Nicknamed "mixbus glue," this compression sound has become the industry standard. WesAudio has improved this design, creating a whole new level of versatility with incredible, modern DAW integration. ngBusComp is a "fully analog" compressor with digital recall and plug-in control of all parameters. Can be used in three modes: dual mono, stereo, and M/S.
・True analog sound with detailed control!
・Total recall and plug-ins
・Controls
・The main VCA uses a quad VCA circuit using four THAT 2181s in parallel
・+26dBu headroom
・Can operate in three modes: dual mono/stereo/MS
・Channel link!
・MID-SIDE operating mode
・Canrhill transformer
・Selectable output circuit: electronically balanced or transformer-balanced output
・"Transformer mode" offers a passive attenuator to drive a transformer if desired
・Parallel
・DRY/WET mix knob for compression
・Unique continuously variable THD control for fine tuning
・Sidechain filters: Three high-pass filters at 60, 90, and 150 Hz, plus a specially designed "Tilt Filter" curve.
・Five ratio settings: 1.5:1 and 2:1 for gentle mix bus processing, 4:1 and 10:1 for a variety of applications, plus INF mode for intense transient limiting.
・External sidechain via TRS connector (rear panel)
・Hardware A/B/C preset buttons
・USB or Ethernet connection! Detailed metering for each channel, displaying input/output and gain reduction Analog with plug-in control Automation Five touch-sensitive Analog in DAW with encoders Automation Record True bypass Fully digitally controlled and isolated analog circuitry Compatible plug-ins Software and firmware Upgradeable THD+N (20Hz-20kHz) 0dBu ＜ 0.006% Frequency response 0-300kHz (-3dB) Input impedance ＞ 10kohm Output impedance ＜ 50ohm Channels crosstalk ＞ 90dB Maximum input level +26dBu Maximum output level +26dBu Dynamic range ＞ 120dB Control Attack: 0.1, 0.3, 1, 3, 10, 30 (ms)Release: 0.1, 0.3, 0.6, 0.9, 1.2, Auto (s)Ratio: 1.5, 2, 4, 10, INF Sidechain Filter: 60, 90, 150, T1, T2THD: 0% to 8%Power 115VSize EIA 3U (D=approx. 270mm: including protrusions)
■Management code: 4560482828692