Daedalus is a plate-style reverb. The initial concept was to replicate the sound of a modern Belton 3-brick reverb. After much trial and error, we added Depth and Preamp circuits, and implemented the idea of ​​an effects loop. By using a discrete JFET preamp circuit and an external effect loop that applies only to the effect component, we can achieve special effects not possible with conventional reverbs. Distort the reverb, add modulation, or pitch shift—the possibilities are endless. Daedalus's Exp jack can be used in two ways: Expression: Connect a pedal to control the reverb amount. Effect: Loop: Connect an external effect to distort or modulate the reverb component. Plate-Style Reverb. Listen to this page (external site). Features: Daedalus is a plate-style reverb. The initial concept for development was the sound of a state-of-the-art Belton 3-brick reverb. After much trial and error, we added Depth and Preamp circuits, and implemented the idea of ​​an effects loop. By using a discrete JFET preamp circuit and an external effect (effects loop) that applies only to the effect component, we can achieve special effects not possible with conventional reverbs. Distort the reverb, add modulation, or pitch shift—the possibilities are endless. Daedalus's Exp jack can be used in two ways:
・Expression
・Connect a pedal to control the reverb amount.
・Effect
・Loop
Connect an external effect to distort or modulate the reverb component. Two Ways to Use the Exp Jack
■ Expression
・Connect a pedal to control the reverb amount. The REVERB knob's maximum setting is the expression. Use a TRS cable for connection. ■ Effects ・Loop: Connect an external effect to distort or modulate the reverb. Connect an external effect using a TRS-to-Y cable (sold separately). ・Tip = Send ・Ring = Return. Preamp control: Pushes the sound. The unit features a discrete onboard JFET preamp. Higher settings boost the reverb, enhancing the decay and reverb time. This also affects the sound, enhancing the slightly distorted compression characteristic of analog. If an external effect is connected to the Exp jack, the effect volume is also amplified. REVERB II Switch: This footswitch allows you to switch between two Reverb (typically Wet) controls. Reverb (normal) sets a short reverb, while Reverb II (footswitch on) sets a long reverb, allowing you to switch instantly. Dimensions: W12 × D9.5 cm Power supply: 9V DC / 75mA / center negative terminal Control code: 4571239309050