This is a reprint version of the Hotshot II, a 4WD buggy that was introduced in 1987 and gained popularity.

Suspension: 4 independent double wishbone wheels equipped with CVA damper II
Stabilizer installed on the front

Built-in differential gear in front and rear sealed gearboxes
The tires are made of hollow rubber with a mix of oval blocks and pin spikes for excellent grip.

[Separately purchased items (not included)] Fine spec 2.4G electric RC drive set, AA batteries for transmitter: 4 pieces
Total length: 390mm *The photo shows the kit assembled and painted.
Body and rear wing are painted and cut

Product introduction This is a reprint version of the Hot Shot II, a 4WD buggy that was introduced in 1987 and gained popularity.
Suspension: 4 independent double wishbone wheels equipped with CVA damper II
Stabilizer installed on the front
Built-in differential gear in front and rear sealed gearboxes
The tires are made of hollow rubber with a mix of oval blocks and pin spikes for excellent grip.
Total length: 390mm
*The photo shows the kit assembled and painted.
Body and rear wing are painted and cut
[Separately purchased items (not included)] Fine spec 2.4G electric RC drive set
AA batteries for transmitter: 4
*A power source is required to drive this product, but batteries, batteries, chargers, etc. are not included.
Also, transmitter, RC mechanism, etc. are not included.
Additional parts purchase, assembly, and painting are required before running.
*This product does not use fuel.
*This product does not include fuel.
*This product does not include paint, adhesives, oil, grease, tools, etc.
Safety Warning: Do not use for any purpose other than its intended purpose.

Dimension: ‎39 x 23.5 x 12.1 cm


Tags:

Car   Wheel   Radio-controlled car   Auto racing   Racing   Motor vehicle   Tire   Chassis   Open-wheel car   Truggy